General Discussion >> Hurricane Ask/Tell

Ed DunhamAdministrator
Former Meteorologist & CFHC Forum Moderator (Ed Passed Away on May 14, 2017)


Reged: Sun
Posts: 2565
Loc: Melbourne, FL
Re: can someone tell me what the colors stand for and the # below it
      Thu Aug 07 2008 12:48 AM

This has got to be one of the best questions that anyone has ever asked on the site - and one of the toughest ones to answer.

Here is a simplified explanation:
The colors to the right are associated with areas of positive vorticity (rising air - bad weather - lower pressure) and the colors to the left represent negative vorticity (sinking air - good weather - higher pressure). The larger the number, the stronger the vorticity (positive or negative).

So the next question is, okay, what is vorticity? Well here goes, but this one is going to 'hurt your head' a little.

Courtesy of: theweatherprediction.com
and
METEOROLOGIST JEFF HABY

"The 500-millibar prog represents the level where about one half of the earth's atmospheric mass is below it and half the earth's atmospheric mass is above it. The number 1 item a forecaster looks for on this prog is advection vorticity. Vorticity is a spinning motion (or eddy) created by directional and/or speed changes in the wind field. This model prog is available on UNISYS weather at:

http://weather.unisys.com/eta/4panel/eta_500_4panel.html

This prog shows colorized 500-millibar absolute vorticity, height contours, and wind vectors. Absolute vorticity is a combination of curvature, shear and Coriolis vorticity. Coriolis vorticity is always positive because the earth rotates counterclockwise when viewed from the North Pole. Curvature or Shear vorticity can be positive OR negative. Since the model shows absolute vorticity, the values of vorticity will be skewed toward positive values (because Coriolis vorticity is always positive). The model determines the value of vorticity for numerous locations across the model panel. These vorticity values are then colored using the scale below the panel.

The normal range of vorticity values are from near zero (or single digit negative) to sometimes more than +30 units. A unit of vorticity is equal to 1 times 10 to the negative 5th with units of seconds to the negative 1. The units of vorticity are derived from the change is wind speed over a horizontal distance. Since wind speed has units of m/s and distance has units of m, the units cancel to seconds to the negative 1. The highest vorticity regions on the panel (caused by the greatest combination of positive shear and positive curvature) are termed vorticity maximums. Positive curvature is a counterclockwise windflow (such as in a trough) and positive shear is a horizontal speed change of wind with distance that causes a counterclockwise rotation.

An eddy of vorticity spins like a low pressure in that it spins counterclockwise. This counterclockwise spin-up causes the air to diverge and rise downwind from the vorticity maximum when there is a wind flow through the vorticity maximum region. A rough guide to the intensity of a vort max is: less than 14: small vorticity; 14 to 20: moderate; 22+ large. The value of the vorticity maximum does not tell the whole story. For strong upward motion to result with a vort max, there must also be a strong wind flow (long wind vectors) flowing through the vort max. A strong gradient in vorticity values is also helpful in strengthening vorticity advection. Strong wind flowing through the vort max will create regions of NVA and PVA, where NVA stands for negative vorticity advection (wind flow region toward the vort max; advection of smaller values of vorticity) and PVA stands for positive vorticity advection (wind flow region away from the vort max; advection of higher values of vorticity). It is the downstream PVA region of a vort max that has upper level divergence and rising air (also called the downwind region of the vort max)."

In your example, you were looking at the 950 millibar level (less than a thousand feet high) rather than the 500MB level that was noted in the description above (about 18 thousand feet high).

Vorticity is one subject that can cause an instant migraine for many mets. Its easier to know what it represents rather than understand how its derived. Personally I like my simple version - hope that this has been of some help. Since I'm an 'old-school' met, maybe someone else can chip in with a clearer explanation (I hope)

Credits to CoconutCandy for providing the corrected link.

Penn State 950MB Vorticity Chart

Cheers,
ED

Post Extras Print Post   Remind Me!     Notify Moderator


Entire topic
Subject Posted by Posted on
* can someone tell me what the colors stand for and the # below it tommy Thu Aug 07 2008 12:48 AM
. * * Atmospheric Vorticity. What does it all mean? CoconutCandy   Thu Aug 07 2008 01:26 AM
. * * Re: can someone tell me what the colors stand for and the # below it Ed DunhamAdministrator   Wed Aug 06 2008 10:25 PM
. * * Re: can someone tell me what the colors stand for and the # below it Ed DunhamAdministrator   Thu Aug 07 2008 12:48 AM
. * * Admin Note on Vorticity Question Ed DunhamAdministrator   Thu Aug 07 2008 06:12 PM

Extra information
0 registered and 0 anonymous users are browsing this forum.

Moderator:  CFHC, Ed Dunham, Colleen A., danielw, Clark, RedingtonBeachGuy, Bloodstar, tpratch, typhoon_tip, cieldumort 



Forum Permissions
      You cannot start new topics
      You cannot reply to topics
      HTML is disabled
      UBBCode is enabled

Rating:
Thread views: 5629

Rate this thread

Jump to

Mobile Home - Login - Normal Flhurricane Site
This is NOT an official page. It is run by weather hobbyists and should not be used as a replacement for official sources.
Generated May 18, 2024, 3:43:23 PM EDT
When in doubt, take the word of the National Hurricane Center